IBM Partner Pavilion Vitrual Switch Extension BMD00082 Benutzerhandbuch
SmartConnect User’s Guide
82
Chapter 6: Configuring Switch Access
BMD00082, February 2009
Apply and Save the Configuration
The apply and save commands are still needed after the last command
(scp ad4.cfg scpadmin@205.178.15.100:putcfg).
Or, instead, you can use the following commands:
(scp ad4.cfg scpadmin@205.178.15.100:putcfg).
Or, instead, you can use the following commands:
The diff command is automatically executed at the end of putcfg to notify the remote
client of the difference between the new and the current configurations.
client of the difference between the new and the current configurations.
putcfg_apply
runs the apply command after the putcfg is done.
putcfg_apply_save
saves the new configuration to the flash after putcfg_apply
is done.
The putcfg_apply and putcfg_apply_save commands are provided because
extra apply and save commands are usually required after a putcfg; however, a SCP
session is not in an interactive mode at all.
extra apply and save commands are usually required after a putcfg; however, a SCP
session is not in an interactive mode at all.
SSH and SCP Encryption of Management Messages
The following encryption and authentication methods are supported for SSH and SCP:
Server Host Authentication:Client RSA authenticates the switch at the beginning of every con-
nection
nection
Key Exchange:
RSA
Encryption:
3DES-CBC, DES
User Authentication:
Local password authentication, RADIUS, SecurID
(via RADIUS, TACACS+, for SSH only—does not apply to SCP)
(via RADIUS, TACACS+, for SSH only—does not apply to SCP)
>> #
scp ad4.cfg scpadmin@205.178.15.157 1022:putcfg_apply
>> #
scp ad4.cfg scpadmin@205.178.15.157 1022:putcfg_apply_save