HP XC System Software 3.2.1 Benutzerhandbuch
Perform the following procedure for each workstation in the hardware configuration. Change
only the values that are described in this procedure; do not change any other factory-set values
unless you are instructed to do so:
only the values that are described in this procedure; do not change any other factory-set values
unless you are instructed to do so:
1.
Establish a connection to the console by connecting a monitor and keyboard to the node.
2.
Turn on power to the workstation.
3.
When the node is powering on, press the F10 key to access the Setup Utility.
4.
When prompted, press any key to continue.
5.
Select English as the language.
6.
Make the following BIOS settings for each workstation in the hardware configuration as
shown in
shown in
Table 4-19 BIOS Settings for xw8600 Workstations
Set to This Value
Option Name
Submenu Name
Menu Name
Separate IDE Controller
After you make this setting, make sure the Primary
SATA Controller
SATA Controller
and Secondary SATA
Controller
settings are set to Enabled.
SATA Emulation
Storage Options
Storage
Set the following boot order on all nodes except
the head node:
the head node:
1.
Optical Drive
2.
USB device
3.
Broadcom Ethernet controller
4.
Hard Drive
5.
Broadcom Ethernet controller
On the head node, set the boot order so that the
Optical Drive is listed before the hard disk.
Optical Drive is listed before the hard disk.
Boot Order
7.
Select File
→Save Changes & Exit to exit the Setup Utility.
8.
Repeat this procedure for each workstation in the hardware configuration.
9.
Turn off power to all nodes except the head node.
10. Follow the software installation instructions in the HP XC System Software Installation Guide
to install the HP XC System Software.
4.5 Preparing the Hardware for CP3000 (Intel Xeon with EM64T) Systems
83