Husqvarna Grinder SG13B Benutzerhandbuch

TROUBLESHOOTING

HUSQVARNA

-47

Pulleys not aligned
Belt tension is insufficient

Adjust belt tension

Tighten the belt as described in the 

operator’s manual
Reduce cutting depth

Damaged axle, pulley or key

Replace damaged parts
Make sure the setscrews are 

properly tightened

Engine speed is insufficient to 

activate the centrifugal clutch
Belt tension is insufficient
Clutch is worn

Make sure the throttle cable is 

working properly
Adjust  belt tension
Replace shoes and springs, and/or 

clutch bearings

Cutting wheel continues to rotate

The engine speed is not under 1000 

rpm, which is required to disengage 

the centrifugal clutch

Check for damage on the throttle 

cable
Check that the throttle cable is 

properly mounted on the throttle 

valve
Inspect springs on clutch shoes, 

if tension on clutch shoes is not 

enough to pull shoes back, replace 

springs and clutch shoes

Adjust the brake tension in the 

manner described in the  

operator’s manual
Check for damage on the brake rod 

or lever
Check for wear on the brake pads. 

replace as necessary