HP Whereis Navigator 2.5 Benutzerhandbuch

 

Whereis® Navigator Installation Guide for HP iPaq with In-Built GPS - version 2.5 

5

The following important components are required to operate Whereis® Navigator: 

 

ƒ  A HP iPaq with an in-built GPS Receiver, ie hw6515 or hw6965. 
 
ƒ  GPRS data communications must be enabled to use this service

contact your telecommunications company to configure or enable data 

communications on your phone.  

 
ƒ  The Whereis® Navigator for HP iPaq devices with in-built GPS.  

 

ƒ  A unique license key for each mobile device you require.  This is included 

with your new HP iPaq and you need to visit 

 

to register.  You should keep this number and any Whereis® Navigator 

CD in a safe place should you need to reinstall.  

ƒ  Please note that each license key has been configured to operate on one 

• 

At least 3.5 MB of free memory for application installation. 

• 

We recommend an in-vehicle charger for your  HP  iPaq  to  ensure  the  best 

battery performance. 

• 

A quality vehicle-mount for your phone. 

• 

We recommend performing a back-up of your device once you have 
successfully installed and configured Whereis® Navigator.  This will allow you 
to restore your device configuration in the event of total battery loss and 

device hard resets (consult your PocketPC user guide for assistance).  The HP 
iPaq has a back up utility which can be found under programs -> HP Backup 

Utility. 

 

                                          

1

 Whereis® Navigator requires you are in mobile coverage to download routes.  You do not require coverage once the route 

is downloaded unless you deviate from the route and require a new route to automatically download.