HP Cell Phone Accessories 8935 Benutzerhandbuch
Chapter 3
59
Utility Procedures
Ports: HP-IB, Serial and Parallel
Chapt
e
r 3
U
til
it
y
P
ro
ro
c
e
d
u
re
s
3. Change the settings for the port as desired.
NOTE
Do not turn Flow Control on (set
Flow Cntl
to “Hardware” in the I/O
CONFIGURE screen) for the serial port until you have a device
attached to the port that can respond to the flow control
communications.
attached to the port that can respond to the flow control
communications.
Example: Assume you have a printer attached to Serial Port 9. Power is
off to the printer. Before you start to run any IBASIC software (for
example, the RFTOOLS program), youmust make sure the printer is
attached and power is on to the printer.
off to the printer. Before you start to run any IBASIC software (for
example, the RFTOOLS program), youmust make sure the printer is
attached and power is on to the printer.
Using Serial Ports for Printing
Serial Port 9 is the only serial port that can be used for printing.
It is not
necessary to change the
Serial_9 In
field.
2. Press
Shift
, then
Print
(Printer Config) to display the PRINTER
CONFIGURE screen.
3. Select
Printer Port
. Choose
Serial 9
to direct the output to
Serial Port 9.
4. Press
Print
to print the currently displayed screen.
Configuring Serial Port 9 for IBASIC Communications
The internal connection to Serial Port 9 is controlled in the I/O
CONFIGURE screen. The port has two purposes with IBASIC:
CONFIGURE screen. The port has two purposes with IBASIC:
•
Inst
: Serial Port 9 is connected to a terminal (e.g. a PC running
Windows Terminal program). IBASIC commands are input from the
terminal and are used to control the Test Set.
terminal and are used to control the Test Set.
•
IBASIC
: Serial Port 9 is connected to a device that can communicate
with an IBASIC program already running inside the Test Set.
Typically used for input/output to a PC or other device.
Typically used for input/output to a PC or other device.
1. Press
Shift
, then
Inst Config
(I/O Config) to go to the I/O CONFIGURE
screen.
2. Select
Serial_9 In
to toggle between
Inst
and
IBASIC
.
Configuring Serial Ports 10 and 11
Serial Ports 10 and 11 are only configured via IBASIC commands. See
the Programmer’s Guide for commands which control these ports.
the Programmer’s Guide for commands which control these ports.
Main Menu