Hitachi 1000 Benutzerhandbuch
www.hitachi.com
BladeSymphony 1000 Architecture
White Paper
27
Table 6 provides information on the connector types for PCI-X I/O Modules.
PCIe I/O Module
To provide more flexibility and to support newer PCI cards, a PCIe I/O module is available. The PCIe I/O
Module supports eight PCIe cards in total, and one I/O module can have one PCIe card assigned per
server blade. The PCIe I/O Module uses a PCIe hot plug controller manufactured by MICREL. Hot plug
is supported for each PCIe slot in the PCIe I/O Module. The operating system must support hog plug in
order for this operation to be successful.
Module supports eight PCIe cards in total, and one I/O module can have one PCIe card assigned per
server blade. The PCIe I/O Module uses a PCIe hot plug controller manufactured by MICREL. Hot plug
is supported for each PCIe slot in the PCIe I/O Module. The operating system must support hog plug in
order for this operation to be successful.
PCIe I/O Module Combo Card
A PCIe I/O Module Combo Card is available for the BladeSymphony 1000, which can be installed in the
PCIe I/O Module and provides additional FC and gigabit Ethernet configurations. The block diagram is
shown in Figure 17. The card includes two1/2/4 Gb/sec. FC ports supporting FC-AL and point-to-point
switch fabric. Two gigabit Ethernet ports are also included. These ports support auto-negotiation and
VLAN (compatible to IEEE 8.2.1Q and a maximum of 4096 TagVLANs).
PCIe I/O Module and provides additional FC and gigabit Ethernet configurations. The block diagram is
shown in Figure 17. The card includes two1/2/4 Gb/sec. FC ports supporting FC-AL and point-to-point
switch fabric. Two gigabit Ethernet ports are also included. These ports support auto-negotiation and
VLAN (compatible to IEEE 8.2.1Q and a maximum of 4096 TagVLANs).
Figure 17. PCIe I/O Combo Card block diagram
Embedded Fibre Channel Switch Module
The Embedded Fibre Channel Switch Module consists of a motherboard, with one daughter card with
an FC switch installed, and eight FC-HBA + Gigabit Ethernet Combo Cards. It enables the use of both
FC and LAN functions from each server blade in the BladeSymphony 1000 chassis. Figure 18 shows
an outside view of this module.
an FC switch installed, and eight FC-HBA + Gigabit Ethernet Combo Cards. It enables the use of both
FC and LAN functions from each server blade in the BladeSymphony 1000 chassis. Figure 18 shows
an outside view of this module.
Table 6: PCI-X I/O Module connector types
Name
Protocol
Frequency
Bus Width
Remarks
PCI-X slots #0 to 7
PCI-X 133
133 MHz
64-bit
PCI Hot Plug
SCSI connector #0, #1
Ultra 320
160 MHz
16 bit LVD
Each I/O module
has two SCSI con-
nector ports
has two SCSI con-
nector ports
LAN
RJ45 (MAG)
LAN
RJ45 (MAG)
Flash
FC
Controller
LED
LED
ROM
Optical module
GbE
Bridge
Optical module