Hitachi DZ-MV780A Benutzerhandbuch

Seite von 190
English
158
No DVD Video Camera/Recorder Operation – 
Check the Following:
Check 1
No movie can be recorded
Movie can be recorded only on DVD-RAM or DVD-
R disc.
Check the following:
• Is proper type of disc inserted?
• Is power switch set to “
O
”?
• Is the DVD-RAM disc in DVD video camera/
recorder write-protected? Release the write-
protect.
• When using DVD-R disc: Has the disc been 
finalized?
• Does disc have remaining recording space?
If movie still cannot be recorded after the above 
check is clear, the disc may be damaged: Use 
another disc.
Check 2
No still can be recorded
Still can be recorded only on DVD-RAM disc or SD 
memory card.
Check the following:
• Is proper type of disc or card inserted?
• Is power switch set to match the recording 
medium?
When using DVD-RAM disc: Set to “
N
”.
If the LOCK switch on this DVD video camera/
recorder is set to 
L
 (upper position), set it to 
K
 (lower position). 
If the LOCK switch is set to 
L
 (upper position), 
switching to “
N
” is not possible.
When using SD memory card: Set to “
P
”.
• Is loaded DVD-RAM disc write-protected?
• When using SD memory card: Is the erase 
prevention switch locked? (p. 27)
• Does disc or card have remaining recording 
space?
If still cannot be recorded after the above check is 
clear, the disc or card may be damaged: Use 
another disc or card.
Check 3
Skip or search playback does 
not work well
If the temperature inside the DVD video camera/
recorder is high, normal operation may not be 
possible. Turn the DVD video camera/recorder off, 
wait for a few moments, and then turn it on again 
for operation.
Check 4
• No operation can be 
performed because the 
ACCESS/PC or CARD 
ACCESS indicator on this 
DVD video camera/recorder 
remains lit or blinking.
• After disc or card is 
inserted, it takes some time 
until recording is possible.
In the following cases, it will take more time than 
usual until operation is possible:
• Immediately after a disc or card is reinserted.
• When a long time has elapsed since the DVD 
video camera/recorder was turned off last.
• When the temperature is greatly different from 
the status of previous recording.
• When disc with scratches, dirt or fingerprints is 
inserted.
• When disc is subject to severe vibrations.
• When the battery or DC power cord was 
disconnected instead of following the correct 
procedure using power switch to turn the DVD 
video camera/recorder off.