GSI Outdoors PNEG-338 Benutzerhandbuch

PNEG-338 Portable Dryer Installation Manual

1. Read and understand the operating manual before trying to operate the dryer.

2. NEVER operate the dryer while the guards are removed.

3. Power supply should be OFF for service of electrical components. Use CAUTION in checking 

voltage or other procedures that require the power to be ON.

4. Check for gas leaks at all gas pipe connections. If any leaks are detected, DO NOT operate dryer. 

Shut down and repair before further operation.

5. NEVER attempt to operate the dryer by jumping or otherwise bypassing any safety devices on 

the unit.

6. Set pressure regulator to avoid excessive gas pressure to burner during ignition and when burner 

is in operation. DO NOT exceed maximum recommended drying temperature.

7. Keep the dryer clean. Clean grain is easier to dry. Fine material increases resistance to airflow and 

requires removal of extra moisture. DO NOT allow fine material to accumulate in the plenum chamber.

8. Keep auger drive belts tight enough to prevent slippage.

9. Use CAUTION in working around high speed fans, gas burners, augers and auxiliary conveyors 

which can all START AUTOMATICALLY.

10. DO NOT operate in any area where combustible material will be drawn into the fan.

11. BEFORE attempting to remove and reinstall any propeller, read the procedure listed in the service 

section of the manual.

12. Match the capacities of auxiliary conveyors to dryer auger capacities.

This dryer is designed and manufactured to maximize operator safety. However, grain dryers have 
inherently hazardous components: a gas burner, high voltage electrical equipment, high speed rotating 
parts, etc. It is not possible to fully safeguard against all hazards without impeding efficient operation 
and reasonable access to components. Therefore, a careful and knowledgeable owner/operator is the 
best insurance against an accident.

Use extreme caution when working around high speed fans, gas fired heaters, augers and auxiliary 
conveyers, which may start without warning when the dryer is operating on automatic control.

Continued safe, dependable operation of automatic equipment depends, to a great degree, upon the 
owner. For a safe and dependable drying system, follow the recommendations within this manual and 
make it a practice to regularly inspect the operation of the unit for any developing problems or unsafe 
conditions.

Take special note of all 

 before attempting to operate the dryer.