Gigabyte 7014 Benutzerhandbuch
Rev. 051208
page 11 of 152
DIN RAIL MOUNTING
Install the unit on a standard 35mm Din-Rail. Recess the 7014TX unit to allow at least 3” of horizontal clearance for fiber cable
bend radius. Recess the 7014FX2 unit to allow at least 5” of horizontal clearance for fiber cable bend radius.
To mount the unit to the 35mm din-rail, place top edge of the bracket
on the back of the unit against the din-rail at an upward angle. Lower
the bottom of the unit until it snaps into place.
Note: When mounting the switch in the vertical position, you must
orientate the power connector to the top as shown above for proper
ventilation.
on the back of the unit against the din-rail at an upward angle. Lower
the bottom of the unit until it snaps into place.
Note: When mounting the switch in the vertical position, you must
orientate the power connector to the top as shown above for proper
ventilation.
To remove the unit from the 35mm din-rail, place a flat
head screwdriver into the release clip at the bottom of the
unit, and push down on the clip until it disengages from
the bottom of the unit from the din-rail. Lift the bottom of
the unit up at an approximate 45° upward angle to
completely remove the unit.
head screwdriver into the release clip at the bottom of the
unit, and push down on the clip until it disengages from
the bottom of the unit from the din-rail. Lift the bottom of
the unit up at an approximate 45° upward angle to
completely remove the unit.
Most N-Tron™ products are designed to be
mounted on industry standard 35mm DIN-
Rail. However, DIN-Rail mounting may not
be suitable for all applications. Our Rack
Mount Assembly (P/N: 900-RM) may be
used to mount the 7014 Series to standard
19" racks as an option.