GE SX TRANSISTOR CONTROL IC3645SR4U404N2 Benutzerhandbuch

SX TRANSISTOR CONTROLS

 

 

 

Page 

 

 

 

January 2000

 

 

 
Section 6.1  General Features 
The GE Handset is a multi-functional tool to be used with 

the LX, ZX, and SX Series GE solid-state controls. The 

Handset consists of a Light Emitting Diode (LED) display 

and a keyboard for data entry.  
Note: The Handset is the same for all GE controls, 
however, the cable will change between some control 
types.  
 
Section 6.2  Purpose / Setup Functions 
The purpose of the Handset is to allow authorized 

personnel to perform the following functions of the SX 

family of Controls: 

•

=Monitor existing system fault codes 

•

=Monitor intermittent random fault codes 

•

=Monitor battery state of charge on systems with BDI 

•

=Monitor hourmeter reading  

•

=Monitor or adjust the following control functions: 

♦

= Creep speed 

♦

= Armature Controlled Acceleration and 1A Time 

♦

= Regenerative Braking Current Limit and Disable 

♦

= Armature and Field Current Limit 

♦

= Plugging Distance (Current) 

♦

= Pedal Position Plug Range or Disable 

♦

= 1A Drop Out Current or Disable 

♦

= Speed Limit Points  

♦

= Truck Management Fault Speed Limit 

♦

= Internal Resistance Compensation for Battery 

State of Charge Indication 

♦

= Battery Voltage ( 36/48 volts is auto ranging ) 

♦

= Selection of Card Operation Type.   

 

 

 

At the transistor control traction card, unplug the "Y plug" if 

the dash display is in use, and plug in the Handset to the 

plug  location "Y" on the control card. After installing the 

Handset tool, plug the battery in and turn the key switch on. 

The following is the start-up display sequence that will 

occur: 

 

Key Switch On

Verify Each LED Segment

8 8 8 8

If Maintenance Code

Is Active

If Maintenance Code

Is Not Active

Display Code "-99"

For Four Seconds and

Activate Speed Limit

(if selected)

BDI Display or

Blank Display
(no BDI used)

Diagnostics Override

With Fault

BDI Display or

Blank Display
(no BDI used)

Diagnostics Override

With Fault

Key Switch

Off

Display Traction  Hourmeter

For Four Seconds

Display Pump  Hourmeter

For Four Seconds

 

 
NOTE: The vehicle can be operated with the Handset 
connected, however, the adjustment knob must be set 
fully clockwise to insure the control operates at top 
speed. 
 
Warning: Before making any adjustments to the control, 
you must consult the operating and maintenance 
instructions supplied by the vehicle manufacturer. Failure 
to follow proper set up instructions could result in mis-
operation or damage to the control system.