Ericsson ATSC Broadcast Receiver RX8320 Benutzerhandbuch
Installing the Equipment
2
Installing the Equipment
2.1
Introduction
For best performance and reliability follow the instructions for site requirements and
installation in the Reference Guide and only use installation accessories
recommended by the manufacturers.
installation in the Reference Guide and only use installation accessories
recommended by the manufacturers.
Warning!
Do not remove the covers of this equipment. Hazardous voltages are present within
this equipment and may be exposed if the covers are removed. Only Ericsson
trained and approved service engineers are permitted to service this equipment.
this equipment and may be exposed if the covers are removed. Only Ericsson
trained and approved service engineers are permitted to service this equipment.
2.2
Operating Voltage
Caution!
This product should be operated only from the type of power source indicated on the
marking label. If you are not sure of the type of power supply to your business,
consult a qualified electrical engineer or your local power company.
marking label. If you are not sure of the type of power supply to your business,
consult a qualified electrical engineer or your local power company.
Note: Refer to the Reference Guide for details of the color codes used on the
mains leads.
See Table 5 for fuse information and also the Reference Guide for a full power
supply specification.
supply specification.
AC Models
AC models are fitted with a wide-ranging power supply. It is suitable for supply
voltages of 100-240 V AC -10% +6% at 50/60 Hz nominal.
2.3
Power Cable and Earthing
Check that the power cable is suitable for the country in which the Receiver is to be
used.
used.
EN/LZT 790 0008/2 R1A
2011-03-30
7 (36)