Elta AL101 Benutzerhandbuch

5

6

Dear customer

,

Please read these Operating Instructions through carefully before connecting your device to the

mains, in order to avoid damage due to incorrect use. Please pay particular attention to the safety

information. If you pass the device on to a third party

, these Operating Instructions must also be

handed over

.

1. Safety switch

2. On/Of

f switch with spinning speed grades 

- 

3. 
Adjustment plate for the cutting strength

4. Leftover tray

. 5. Positioning arrows for the sled tray

6. Sled

7. Footing with a rubber base

8. Serrated cutting knife

9. Wing screw of the cutting knife locking

10. Power cable with power plug

11. Dial for the cutting strength

•

Incorrect operation and improper use can damage the appliance and cause injury to the user

.

•

The appliance may be used only for it’

s intended purpose. No responsibility can be taken for any

possible damage caused through incorrect use or improper handling.

•

Before connecting the appliance to the power source, check that the current and power match

those given on the rating plate.

•

Do not put the appliance or the plug in water or any other liquid. However should the appliance

accidentally fall into water

, unplug the appliance immediately and have it checked by a qualified

person before using it again. 

•

Never attempt to open the housing yourself.

•

D

o not place any kind of object into the inside of the housing.

•

Do not use the appliance with wet hands, on a damp floor or when the appliance itself is wet.

•

Do not touch the plug with wet or damp hands.

•

Check the cord and the plug regularly for any possible damage. If the cord or plug is damaged, it

must be replaced by the manufacturer or a qualified person in order to avoid a hazard.

•

Do not use the appliance if it is dropped or otherwise damaged or if the cord or plug are damaged.

In the case of damage, take the appliance to an electrical repair shop for examination and repair if

necessary

.

•

Never attempt to repair the appliance yourself. 

•

Do not allow the cord to hang over sharp edges and keep it well away from hot objects and naked

flames. Remove the plug from the socket only by holding the plug.

•

For extra protection it is possible to fit the electric household installation with a fault current

breaker with a rated breaking current of not more than 30mA. 

Ask your electrician for advice.

•

Make sure that there is no danger that the cord or extension cord may inadvertently be pulled or

cause anyone to trip when in use.

•

If an extension cord is used it must be suited to the power consumption of the appliance,

otherwise overheating of the extension cord and/or plug may occur

.

•

This appliance is not suitable for commercial use nor for use in the open air

.

•

Never leave the appliance unattended while it is in use.

•

Children cannot recognise the dangers involved in the incorrect use of electrical appliances.

Therefore never allow children to use household appliances without supervision.

•

Always remove the plug from the socket when the appliance is not in use and each time before it

is cleaned.

•

Nominal voltage is still present in the appliance as long as the appliance is connected to

the mains socket.

•

Switch the appliance of

f before disconnecting from the mains.

•

Never use the cord to carry the appliance.

•

: Never use the device for more than

. Before operating

the device again, let it 

to room temperature first.

•

The cutting knife 

is very sharp. 

Y

ou should exercise extreme caution when cleaning

the device.

•

After you finish cutting, always set the On/Of

f switch 

back to the 

position. 

Also, set the dial

1)
back to the minimal cutting strength. Pull the power plug.

•

Never feed the device with your bare hands. 

Always use the cutting sled

and the leftover tray

to do so.

•

Do not use the device, unless all parts are properly installed.

•

Remove the cut food, only once the cutting knife 

has come to a complete stop.

•

The leftover tray

has very sharp edges. 

Y

ou should exercise extreme caution when

cleaning the device.

•

T

he device is suitable for cutting of bread, sausage, meat, vegetables and fruit. 

Y

ou should not

use it to cut:

• Meat with bones

• Foods with pits

• Hard, inedible parts of foods

• Frozen foods

• 

T

wisted and rolled roasts 

As well as similar foods.

•

Remove all packaging.

•

Clean the device as described in 

.

•

P

lace the device on a flat, stable surface and flap down the footing

(7)
.

•

T

o insert the cutting sled into the device, align the arrow of the sled

with the arrow of the

footing 

(7)
. 

The sled is now connected to the footing 

and can be slid back and forth.

•

Insert the leftover tray 

from the top into the duct of the sled 

(6)
, as shown in the illustration

below the 

.

•

Adjust the dial 

1)
to the desired cutting strength.

•

P

lace the food on the cutting sled 

and use the leftover tray 

) to lightly push the food towards

the cutting knife 

(8)
.

1

2

3

4

5

6

11

9

10

7

8