Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Eltax
  4. AVR-320
  5. Benutzerhandbuch

Eltax AVR-320 Benutzerhandbuch

Download
Seite von 24
20 
TEST TONE, LFE TRIMMER & CHANNEL SELECT
 
TEST TONE 
Speaker Level balance Adjustment 
The test tone function is useful to adjust the relative volume between 
speakers in DOLBY DIGITAL or DOLBY PRO LOGIC II mode. 
Once the balance is set, you don’t have to change the balance as 
long as the speakers aren’t moved. 
1. Adjust the MASTER VOLUME to the normal listening level. (Half 
of max. Volume is recommended) 
2. Press the TEST TONE button (on the remote control) in DTS, 
Dolby Digital or Dolby PRO LOGIC II mode. 
  The test tone is emitted from each speaker each time you press 
“TEST TONE”. 
 
 
 
 
  →L(FRONTLEFT)→R(FRONTRIGHT)→LS (SUR. LEFT)   
      ←  SUB  ←  C (CENTER) ← RS (SUR. RIGHT)     
 
3. Select a speaker by pressing the “TEST TONE” button and 
adjust the level by pressing the MASTER VOLUME button. 
The level of each speaker can be adjusted in 1 dB step from –10 
dB to +10 dB. 
4. When the setting is finished, press the TEST TONE button to 
stop the test tone. (Note: You must keep press TEST TONE until 
one complete cycle is finished.) 
 
 
LOW FREQUENCY EFFECT 
 
LFE (LOW FREQUENCY EFFECT) MIX LEVEL (LFE MIX)   
initial setting: 0 dB 
 
Under COAX./OPT mode, when playing a Dolby Digital or DTS 
5.1CH signal, LFE will appear on the display. Press the LFE key on 
the remote and press the VOL +/- button to adjust the level between 
0dB to –10dB. (Note: The LFE adjustment function will resume to 
normal, if the VOL +/- button is not pressed within 5 seconds.) 
 
 
 
 
 
 
 
 
CHANNEL SELECT 
Balancing volume between speakers in 5.1 channel mode when 
using the 5.1 analogue inputs. 
As the Dolby Digital signal is decoded in the external source, 
sometimes, you may have to balance volume between speakers due 
to the location of speakers. In this case: 
 
 
 
1. Press “CH SELECT” on the remote, the following loop will 
appear on the display: 
   
  → L(FRONT LEFT)→R (FRONT RIGHT)→LS (SUR. LEFT)   
      ←  SUB ← C (CENTER) ←   RS (SUR. RIGHT) ←   
 
2. Adjust the Master Volume to balance all speakers. 
 
The level of each speaker can be adjusted in 1 dB steps 
from –10 dB to +10 dB. 
(Note: If the Master Volume is not adjusted for 5 seconds in 
Channel Trimmer state, it returns to normal state.)