Eltax AVR-800 Benutzerhandbuch

Before Use

Speaker Connections

Caution:

To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting
the speakers.

< Check the impedance of your speakers.

Connect speaker with an impedance of 8 ohms or more.
The amplif ier 's r ed speaker t er minals ar e t he

(positive) terminals and the black terminals are the _
(negative) terminals.

< The + side of the speaker cable is marked to make it

distinguishable from the _ side of the cable. Connect
this marked side to the red + terminal and the unmarked
side to the black terminal.

< Prepare the speaker cords for connection by stripping

off approximately 10 mm or less (no more as this could
cause a short-circuit) of the outer insulation.
Twist the wires t ight ly together so that they are not
straggly :

How to connect

Press the lever, insert the st ripped and twist ed end
(approx. 3/ 8") of the cord, then release the lever :
Make sure it is fastened securely by pulling the cord
lightly.

CAUTION

Turn off t he power of all t he equipment before making
connections.
Read instructions of each component you intend to use
with this unit.

< Be sure to insert each plug securely. To prevent hum

and noise, do not bundle the connection cords with the
power cord or speaker cord.

Read this before operation

< Choose the installation location of your unit carefully.

Avoid placing it in direct sunlight or close to a source of
heat . Also avoid locat ions subj ect t o vibrat ions and
excessive dust, heat, cold or moisture.

< The ventilation holes should not be covered. Make sure

t here is enough space

above and beside t he

amplifier/ receiver (about 4 inches). Do not place a CD
player or other equipment on top of the amplifier/ receiver.

< Do not open the cabinet as this might result in damage to

the circuitry or electrical shock. I f a foreign object should
get into the set, contact your dealer.

< When removing the power plug from t he wall out let ,

always pull directly on the plug, never yank the cord.

< Do not attempt to clean the unit with chemical solvents

as this might damage the finish. Use a clean, dry cloth.

< Keep this manual in a safe place for future reference.

Back-up Memory Function

This is the function which preserves the preset memory and
most-recent memory functions. I n the event of a power
failure, or if the power cord of this unit is disconnected from
the electric outlet, the back-up memory will preserve the
preset memory and most-recent memory functions for as
long as approximately 3 days.

I f the power supply is interrupted for 3 days or longer, the
memory settings will be erased.

When to Use RESET Switch

< When this system is subjected to an electrical shock.
< When the power is irregular.

In these cases, try the following

Press the TUNI NG MODE button for more than 5 seconds.

Note:

I f the TUNI NG MODE button is pressed for more than 5
seconds Standby mode, all the memory will be erased.

Read this before operation

Before Connection