Electrolux FN620K Benutzerhandbuch

•      Loosen nut “A”.
•     Insert stake support between engine bracket halves 

with stake spring down. 

•      Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tighten se curely. Tighten nut “A”.

•     Depth stake must move freely. If it does not, loosen 

support bolt.

•      Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just -
ments section of this manual).

•     Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 
Ser vice and Adjustments section of this manual).

•      Check tine operation before fi rst use.  (See “TINE OP-

ERATION CHECK” in the Service and Adjustments 
section of this manual). 

IMPORTANT: 

WHEN UNPACKING AND AS 

SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK 
CABLE(S).

•      Cut cable ties securing handles.
•      The handle may be assembled in high or low position.  

Slowly lift  handle as sem bly up, route cable(s) as shown 
and align han dle holes with desired handle panel hole 
and slot.

•     Loosely assemble hardware as shown.  Be sure the

shorter (3/4" long) hex bolt is assembled in lower 
hole of handle.  Repeat for opposite side.   Tight en all 
hard ware se cure ly. 

NOTE: Cables must not touch the muffl er.
•     Cut cable ties securing tiller to skid and remove tiller 

from skid.

•      Remove screws securing depth stake to skid and dis-

card the screws.