CyberHome Entertainment CH-RDV 2000 Benutzerhandbuch

Once the DVD Player is properly connected to your TV and possibly your receiver also, turn on your TV and make 
sure it’s set to the correct input channel. The video input is usually configured as channel 0 or 1 on most TVs, but 
may be referred to as “Input 1” or “Aux In” or similar names. These procedures assume you are using a NTSC-
compatible TV - standard for North and South America. If you are using a PAL-type, you will need to change the TV 
Type first. In this case, see pg 39 - Video Setup Options. 

Push the Power Button on the back of the unit firmly to turn 
on the player. You should see the message “ON” in the DVD 
Display. Then, the player will attempt to read a disc. With no 
disc in the unit, the message INSERT DISC will be displayed. 

Ÿ Your DVD Player is 

Once the back power switch is in the ON position, the unit 
can be turned off and on by the remote. When the unit is 
turned off by the remote, it will go into STANDBY MODE. 
This allows the unit to be quickly “awakened” by pressing the 
POWER key on the remote again. 

Press the OPEN/CLOSE button on the remote or on the 
player (to the right of the disc tray) to insert a disc. There are 
two grooves in the disc tray - 12cm and 8cm. Make sure the 
disc is properly set into the tray. Small 8cm discs must be 
positioned exactly in the middle groove. Press the 
OPEN/CLOSE button again to close the disc tray. You will 
see the message READ on the display. Once the disc is 
read, you should see the menu screen for DVD discs, or 
hear sound for an Audio CD. 

Most DVDs will automatically display a menu when inserted. 
However, some discs will require you to press the PLAY 
button. Also, the PLAY button can usually be used to quickly 
start a DVD movie when pressed with the menu displayed. 
This function varies with discs. 

17

Once the main power switch on the back of the unit is on, the 
Front power switch can be used to bring the player in and out 
of STANDBY MODE.