CTC Store Switch SB142 Benutzerhandbuch
MNX10015 / Rev B
4/11/2008
4
1. For SB142 Series Switch Boxes (Fiberglass Enclosure): Attach the
enclosed mounting brackets to the Switch Box at the pre-determined
locations (SB242 Series Switch Boxes {Stainless Steel} are supplied with
mounting brackets attached)
locations (SB242 Series Switch Boxes {Stainless Steel} are supplied with
mounting brackets attached)
Note: If you have purchased a switch box without cable entries
provided, you should add your own entry prior to mounting the switch
box.
Note: CTC does not recommend putting holes in the top of the switch
boxes due to access and moisture concerns.
2. Conduit Entry: If you are running conduit to your switch box, ensure the
conduit cable entry enters from the bottom of the enclosure when mounted.
(Figure 3)
(Figure 3)
Note: To ensure moisture will not flow into the switch box, a hole should
be drilled at the lowest point in the conduit to provide drainage for any
moisture.
Figure 2. Mounting Bracket Placement
Mounting
Brackets
Brackets
Figure 3. Conduit Entry for Switch Box
Correct
Incorrect
Drill Drain
Hole Here