Crestron electronic TPS-GA-TPI Benutzerhandbuch

Isys

®

 G-Series Touchpanel Interface 

 

Crestron TPS-GA-TPI

•  Isys

•  If the rack is provided with stabilizing devices, install the stabilizers before 

mounting or servicing the unit in the rack. 

NOTE:  If rack mounting is not required, rubber feet are provided for tabletop 
mounting or stacking. Apply the feet near the corner edges on the underside of the 
unit. 

NOTE:  Reliable earthing of rack-mounted equipment should be maintained. 
Particular attention should be given to supply connections other than direct 
connections to the branch circuit (e.g. use of power strips). 

To install the ears: 

1.  There are screws that secure each side of the TPS-GA-TPI top cover. Using 

a #2 Phillips screwdriver, remove the three screws closest to the front panel 
from one side of the unit. Refer to the diagram following step 3 for a 
detailed view. 

2.  Position a rack ear so that its mounting holes align with the holes vacated 

by the screws in step 1. 

3.  Secure the ear to the unit with three screws from step 1, as shown in the 

following diagram. 

USE COVER SCREWS

 

4.  Repeat procedure (steps 1 through 3) to attach the remaining ear to the 

opposite side. 

 

Four “feet” are provided with the TPS-GA-TPI so that if the unit is not rack 
mounted, the rubber feet can provide stability when the unit is placed on a flat 
surface or stacked. These feet should be attached prior to the hookup procedure by 
removing the adhesive backing and pressing them onto the bottom of the device. 
Refer to the following illustration for placement of the feet.