Futaba 10CAG Gebrauchsanleitung
103
DELAY
: The Delay function provides a smooth transition between the trim positions whenever OFFSET, REVO. MIXING, or
THROTTLE HOLD
functions are turned on and off.
Adjustability:
• Separate delay times are available for aileron, elevator, rudder, throttle, and
• Separate delay times are available for aileron, elevator, rudder, throttle, and
pitch.
• With a 50% delay setting, the servo takes about a half-second to move to its
new position...quite a long time.
,QJHQHUDOGHOD\VRIDSSUR[LPDWHO\DUHVXI¿FLHQW
GOAL of EXAMPLE:
STEPS:
INPUTS:
Set up a delay on all channels to ease
WKH WUDQVLWLRQ IURP RQH ÀLJKW FRQGLWLRQ
to another so there are no "hard jumps."
WKH WUDQVLWLRQ IURP RQH ÀLJKW FRQGLWLRQ
to another so there are no "hard jumps."
Open the DELAY function.
for 1 second.
(If BASIC,
again.)
C
to DELAY.
Adjust AILE response as needed. (Ex:
aileron to +8%.)
aileron to +8%.)
to +8%.
Repeat for other channels.
C
to ELEV. Repeat step above.
C l o s e m e n u s a n d c o n f i r m s l o w e d
transitions.
transitions.
E (T10CHG) or G (T10CAG)
from NORMAL to IDL2. Check that servos
move gradually to new positions.
move gradually to new positions.
Where next?
THR-HOLD
: see p. 99.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
(THR-CURVE, PIT-CURVE, REVO. MIX) for idle-ups: see p. 101.
(THR-CURVE, PIT-CURVE, REVO. MIX) for idle-ups: see p. 101.