Country Home Products Garden Cart Benutzerhandbuch

14   NEUTON

®

 GARDEN CART 

Safety & Operating Instructions

Figure 3. Aligning the wire harness and attaching the wheels. 

First, align the wire harness, then attach the rear caster 
wheel and the front wheels. 

• 

   Thread the wire harness underneath the rear mounting 

plate (Figure 3).  This helps keep the wire harness from 
flopping around once you turn the Cart over.  
Threading the wire harness might prove a little tricky; 
just stick with it.  

• 

   Remove any kinks and twists from the wire harness 

once it’ s through. 

• 

   Position the rear caster wheel over the receiving holes 

in the rear mounting plate on the lower bucket    
(Figure 3).  The caster plate aligns lengthwise with the 
mounting plate.  If the holes don’t align, try twisting 
the plate a quarter turn. 

• 

   Open the clear hardware bag.  First place a 1/4" lock 

washer on the 1/4" x 1" screw, then a 1/4" large flat washer.  
Insert a screw and washer through each of the holes on the caster 
plate  (Figure 3). 

• 

   Use your hands to align and loosely screw in the screws.                                                              

Once all four are loosely screwed in, tighten them down                                                                    
snugly with a Phillips screwdriver.  Again, don’t over-tighten 
them. 

• 

   On each front wheel, find the side stamped INSIDE (look on the 

wheel’s hub).  Slide that side of the wheel onto the drivetrain. 
Align the finger slots on the drive train’s hub with the spokes of 
the wheel rim (Figure 4).  Insert a wheel bolt through the wheel 
bearing and into the drive train (Figure 3). 

• 

   Use your hands to align and loosely screw the wheel bolts into the 

threads inside the drive train.  Tighten with an adjustable wrench (a 17-mm wrench works nicely too), but 
not too tight.  Make sure the wheels spin freely. 

NOTE:  Do not over tighten the bolt.  We designed the wheel assembly to have a slight bit of “play” in it, even 

• 

   Turn the completed bucket assembly over onto its wheels. 

 

 

Tip:  Here’s an easy way to turn the Cart over, simply rotate the Cart over on its nose.  Grab the lower 

handles together with the wire harness, bring the rear caster up and over the drive train, onto the 
bucket face, and down on the front wheels.