Fortinet FortiGate 4000 Benutzerhandbuch

Seite von 332
42
Fortinet Inc.
Hot swapping modules
Getting started
Hot swapping FortiBlade-4010 modules
Follow this procedure to hot swap the FortiBlade-4010 modules. For information about 
the FortiBlade-4010 module, see 
1
Press the power button on the front panel of the FortiBlade-4010 module that you 
want to replace.
The PWR LED on the FortiBlade-4010 module goes out.
2
Loosen the two mounting knots that fasten the module system tray to the 
FortiGate-4000 chassis. Do not remove the mounting knots.
3
Holding the FortiBlade-4010 module by the module lock and handle, slide it out of the 
chassis.
4
Holding the new FortiBlade-4010 module by the module lock and handle, insert it into 
the chassis.
5
Slide the FortiBlade-4010 module into the slot until the lock clicks into place.
6
Tighten the mounting knots on the top of the front panel of the FortiBlade-4010 
module.
7
Press the power button on the FortiBlade-4010 module.
The PWR LED on the FortiBlade-4010 module lights.
Hot swapping cooling fan trays
Each FortiGate-4000 unit has four cooling fan trays. See 
 for more information.
Follow this procedure to hot swap a cooling fan tray.
1
From the rear panel of the FortiGate-4000 chassis, pull out the cooling fan tray you 
want to replace by the handle.
2
Holding the new fan tray by the handle, insert it into the chassis.
Hot swapping power supplies
The FortiGate-4000 power supply modules are secured to the chassis by a locking 
handle and a locking strip located at the bottom of the modules. For more information, 
see 
Follow this procedure to hot swap a power supply module.
1
On the power supply module that you want to replace, turn off the power supply.
2
From the rear panel of the FortiGate-4000 chassis, unscrew the two locking screws 
that fasten the locking strip of the power supply modules. See 
.
3
Remove the locking strip.
4
Lift up the locking handle of the power supply to be removed.
5
Pull out the power supply module by the handle.
6
Holding the new power supply module by the handle, insert it into the chassis.
Note: Wait at least five seconds after turning off the power before removing the FortiBlade-4010 
module from the chassis.