Garmin Vector S Anleitung Für Quick Setup

Do not overtighten the release tension screw on the bottom of 

the pedal. The release tension should be adjusted equally for 

both pedals.

Use a 3 mm hex key to adjust the release tension of each 

pedal.
There is a window on the back of the pedal binding that 

shows the allowable range.

Before you can view Vector data on the Edge device, you must 

pair the devices.
Pairing is the connecting of ANT+™ wireless sensors. This 

procedure contains instructions for the Edge 1000. If you have 

another compatible device, see your owner's manual, or go to 

. 

Bring the Edge device within range (3 m) of the sensor.
NOTE: Stay 10 m away from other ANT+ sensors while 

pairing.

Turn on the Edge device.

From the home screen, select   > Sensors > Add Sensor > 

Power.

Rotate the crank arm a few times.

When the sensor is paired with your Edge device, the sensor 

status is Connected. You can customize a data field to display 

Vector data.

Before you ride with Vector for the first time, you must enter the 

crank length, set the installation angle of the sensors inside the 

pedals, and calibrate the static zero reference. You must also 

calibrate the system if you move Vector to another bike.
These procedures contain instructions for the Edge 1000. If you 

have another compatible device, see your owner's manual or go 

to 

The crank length is often printed on the crank arm.

Rotate the pedals a few times in order to activate Vector.

From the home screen, select   > Sensors >   > Sensor 

Details > Crank Length.

Enter the crank length, and select  .

Before you set the installation angles, you must set the Edge 

data fields to display power and cadence.

Go for a short ride on a trainer or on the road.

Ride until the cadence is nearly 70 rpm.

Accelerate smoothly to approximately 90 rpm.
When the installation angles are successfully set, a message 

appears and data fields display power data on the Edge 

device.

NOTE: During this task, the bike must be in an upright position, 

and nothing can be touching the pedals.

From the home screen, select the status bar or swipe down 

from the top of the screen.
The connections page appears.

Select   > Calibrate.
When the zero reference is determined, a message appears 

on the Edge device.

For best results, Garmin recommends calibrating Vector at the 

start of every ride.

Perform a static zero calibration.

Go for a ride.

You can get the latest owner's manual from the web.

Go to 

.

Select Manuals.

Follow the on-screen instructions to select your product.

If you are transporting your bicycle or not using Vector for an 

extended period of time, Garmin recommends removing Vector 

and storing it in the product box.

3