FieldServer Technologies Video Game Controller 1.1 Benutzerhandbuch
Ruinet Utility User Manual
Page 33 of 46
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
If the FieldServer cannot contact a DHCP Server, the FieldServer will use the last good
IP address it was configured with.
IP address it was configured with.
2.11.3.
Obtain the IP address using the FieldServer’s DHCP Server
The FieldServer can be used as a DHCP Server to allocate an IP address to a PC or
Laptop that you want to use to connect with RuiNet to the FieldServer.
Laptop that you want to use to connect with RuiNet to the FieldServer.
Enable the DHCP Server on the FieldServer.
• Enable the DHCP Server on Ethernet port N1 and / or N2 by pressing “5” or “A”
• Enable the DHCP Server on Ethernet port N1 and / or N2 by pressing “5” or “A”
• Press
“Y” <Enter> to enable or “Esc” to escape. “N” will disable the DHCP
client
• Press any key to continue and escape back to the main menu. Press”!” to
restart the FieldServer
When connecting a PC or Laptop to the FieldServer on port N1 (or N2 for X40), be sure
to enable the DHCP Client function on the PC or Laptop. The following screen-shot from
the Network Connection’s properties on a Windows XP PC shows the TCP/IP settings
needed to enable the PC’s DHCP Client:
Figure 2.19
Simply restart the PC while connected to the FieldServer and it will obtain an IP address
from the FieldServer.
NOTE: Some implementations of the Microsoft DHCP Client will not use an IP address
lease offered by the FieldServer until its previous lease has been released. The way to
release and renew a lease on a PC is to open a command prompt window and use the
following commands (syntax may be different on Windows other than XP):
from the FieldServer.
NOTE: Some implementations of the Microsoft DHCP Client will not use an IP address
lease offered by the FieldServer until its previous lease has been released. The way to
release and renew a lease on a PC is to open a command prompt window and use the
following commands (syntax may be different on Windows other than XP):
Select TCP/IP and
then properties
then properties