Cisco Systems 2.7 Benutzerhandbuch
5-15
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
To configure the WDS access points using the IOS command line interface:
Step 1
Log in to an access point that will be a WDS device.
Step 2
Turn on AAA services:
aaa new-model
Step 3
Define the RADIUS servers that you will use for infrastructure authentication
and/or client authentication. Consult your RADIUS server documentation for the
correct port numbers. CiscoSecure ACS uses port 1645 for authorization and port
1646 for accounting.
and/or client authentication. Consult your RADIUS server documentation for the
correct port numbers. CiscoSecure ACS uses port 1645 for authorization and port
1646 for accounting.
radius-server host [
ip_address
|
hostname
] auth-port
port
acct-port
port
key
shared_secret_key
Step 4
Define a server group for infrastructure authentication:
aaa group server radius
server_group_name
server
radius_server
Step 5
Define at least one additional server group for wireless client authentication.
Step 6
Configure the AP to run WDS:
wlccp wds priority
priority
interface BVI1
where priority is a value from 1 to 255. Priority determines which AP will be the
active WDS AP when multiple APs are configured to run WDS. The highest
priority is 255.
active WDS AP when multiple APs are configured to run WDS. The highest
priority is 255.
Step 7
Configure the Wireless Network Manager (WNM) component:
wlccp wnm ip address
wlse_ip_address
where wlse_ip_address is the address of the WLSE.
Step 8
Configure the server group the WDS will use to LEAP authenticate SWAN
infrastructure access points. Use the server group name that you created in Step 4.
infrastructure access points. Use the server group name that you created in Step 4.
aaa authentication login
named_authentication_list
group
server_group_name
wlccp authentication-server infrastructure
named_authentication_list