Farallon Communications QMS 4525 Benutzerhandbuch
Adjusting the Paper
Size Switch
Size Switch
QMS 4525 Print System User's Guide
4-12
Adjusting the Paper Size Switch
If you have the stacker/stapler installed, a device in the upper output
bin taps printed sheets into a neat stack. For this to work properly, the
paper-size switch must be set to the correct paper size. The switch
has three positions:
bin taps printed sheets into a neat stack. For this to work properly, the
paper-size switch must be set to the correct paper size. The switch
has three positions:
7
Replace the toner bin lid, and push the developing
unit back into its home position.
unit back into its home position.
8
Pull the green handle toward you, then turn it 180°
clockwise until the tab seats into the square hole in
the metal handle of the developing unit.
clockwise until the tab seats into the square hole in
the metal handle of the developing unit.
9
Close the front door.
Left
Foolscap (8.0", 203 mm)
Quartol (8.0”, 203 mm)
Center
A4 (8.3", 210 mm)
Commercial (8.3", 210 mm)
Folio (8.3", 210 mm)
Right
Letter (8.5", 216 mm)
Letter Large (8.5", 216 mm)
Legal Small (8.5", 216 mm)
When you load paper into the
input bins, check the paper
size switch setting to ensure
that it is set properly. If you
load paper of different sizes in
the two input bins, set the
switch to the widest size.
input bins, check the paper
size switch setting to ensure
that it is set properly. If you
load paper of different sizes in
the two input bins, set the
switch to the widest size.
3DSHUVL]H
6ZLWFK