Axis International Marketing 2110 Benutzerhandbuch

In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS 
2110. This is performed by clicking the appropriate button within the Administration Tools, or by 
pressing the Control Button. Follow the instructions below to reinstate the product factory default 
settings using the Control button:

1. Switch off the AXIS 2110 by disconnecting the power cable.
2. Press and hold the Control Button depressed, and reconnect the power supply cable.
3. Continue to keep the Control Button pressed until the Status Indicator displays yellow (note that 

this may take up to 15 seconds), then release the Control Button. When the Status Indicator 
displays green (which can take up to 1 minute) the AXIS 2110 will then have been reset to the 
original factory default settings.

Reinstating the original default settings causes all parameters (including the IP address) to be 
reset. 

The AXIS 2110 can be mounted on the supplied mounting assembly, or installed into a weatherproof 
enclosure for use in outdoor applications. For further information on outdoor enclosures, follow the 
camera accessory links at the Axis website at www.axis.com

Having mounted the AXIS 2110, focus the camera following the instructions below:

When mounting the camera behind glass, make sure that the camera lens is not too far away from 
the glass - particularly when installing the unit in an outdoor enclosure. This will help reduce 
undesirable reflection within the image.

Although the AXIS 2110 is intended for indoor and outdoor use, it is important to note that the charged coupled 
device (CCD) in the camera can become permanently damaged if it is exposed to too much direct sunlight, or halo-
gen light. Therefore, it is important that the Iris Adjustment Ring is not set fully open when installing the camera in 
bright light conditions. The Axis warranty does not cover CCD damage caused by prolonged exposure to strong light. 



Rotate the Focus Ring to an 

appropriate positon - until you 
are satisfied with the focus of 
the camera image.

Status Indicator

Power-on the AXIS 2110 and wait 10 seconds.

Control Button

Iris Adjustment Ring

Tele/Wide Zoom Ring

Focus Ring



The Iris Adjustment Ring effectively closes and 

opens the camera lens to regulate the amount of 
light entering the camera. Closing the ring reduces 
the amount of light; this protects the CCD and 
gives a better depth of field, i.e. focus over a 
greater distance.  A more open lens provides better 
results in low-light conditions.

Rotate the Iris Adjustment Ring to an appropriate 
position for your chosen installation, as follows:

• indoor scene - fully open (O)
• outdoor scene - mid position

(between C and O)



Start your browser applica-

tion and check the picture.  
Adjust the Tele/Wide Zoom 
Ring to a suitable postion for 
your application.

2110ig_master_smaller.fm  Page 5  Friday, September 14, 2001  12:54 PM