Avaya Bogen PCM Paging Control System Installationsanweisungen

[38]

32 paging zone groups can be created. Each zone group can consist of up to 99 zones. To create a zone group:

1. Dial [*] followed by 2-digit number of zone group (01 - 32) you want to create. Follow this with the 2-digit
number of the zones you want to include in the zone group. 

Example: If you want to create zone group 7 consisting of zones 2, 3, and 12, you would dial: 
[*] [0] [7] [0] [2] [0] [3] [1] [2] [#]

NOTE: When finished, save the zone group data into memory by pressing [#].

2. Repeat the above procedure to program additional zone groups.

Press [*] and the 2-digit zone group number, then press [#]. Once done, any attempt to call the zone group will
produce a busy tone.

Use the following procedure to create the signaling zone groups (Emergency/Shift Change, Night Ring, Code Call).

1. Dial the Feature Code for the zone group you wish to create ([*] [9] [2] for EM/SC, [*] [9] [3] for Night Ring, or
[*] [9] [4] for Code Call).

Then dial the 2-digit numbers of the zones you want to be in the zone group.

Example: If you want to create the EM/SC zone group consisting of zones 2, 3, and 12, you would dial:
[*] [9] [2] [0] [2] [0] [3] [1] [2] [#]

NOTE: When finished, save the zone group data into memory by pressing [#].

2. Repeat the above procedure to program additional zone groups.

If the PCM system is connected to a PBX station port, you can set the maximum page duration (default timer). The
factory default for this timer is 30 seconds. If you wish to inhibit the default timer, enter the Feature Code followed
by "00". To change the time, enter the Feature Code and the new 2-digit number corresponding to the time desired.
The 2-digit number represents 10s of seconds (see Note 3 in Notes to Feature Codes on page 44).

If the PCM system is connected to a station port, you can set the default timer for the VOX time out. The default
value is 6 seconds.  To inhibit the timer, enter the Feature Code followed by "0". To change the time, enter the
Feature Code followed by a single digit from 1 to 9, corresponding to 1 to 9 seconds.

When the dialing timeout is enabled, the user must dial a DTMF digit within 15 seconds of the last digit or else the
system will produce an error tone. The user will then have to hang up and access the system again. In station access
mode, the PCM will drop the line after 5 seconds of error tone. This will free the paging system for another page
access.