Autostart Keyless Entry and Alarm System ASL-550 Benutzerhandbuch
P. 10
User Guide
Disarming and Unlocking Doors
If the system was programmed in passive mode, to disarm the system and unlock the doors, press
and hold the
and hold the
UNLOCK
button until the siren chirps twice in confirmation. Notice also that the parking
lights confirm the system disarming by flashing twice. Once the system is disarmed, you have to
open a door within a 35-second delay or else the system will rearm (LED flashing slowly). If the
entry delay expires, you must disarm the vehicle by pressing the
open a door within a 35-second delay or else the system will rearm (LED flashing slowly). If the
entry delay expires, you must disarm the vehicle by pressing the
UNLOCK
button to enter the
vehicle. Once inside the vehicle, you have up to 35 seconds to turn the key switch to the ON
position or start the car to prevent the system from rearming again. If this is not done, your system
will rearm (LED flashing slowly) and, if your system has a Starter Kill, you will not be able to start
the car. If this situation occurs, you need to disarm the car by pressing the
position or start the car to prevent the system from rearming again. If this is not done, your system
will rearm (LED flashing slowly) and, if your system has a Starter Kill, you will not be able to start
the car. If this situation occurs, you need to disarm the car by pressing the
UNLOCK
button.
Starter Disable
Among the many features, the starter disable circuit will immobilize the vehicle when the system is
armed (If installed). The system, when armed, will control a relay that will physically interrupt the
vehicle starter wire and prevent the starting of your vehicle. The system is selectable, passive or
active arming; this means that you can have the unit arm itself (passive) after a pre-programmed
period of time, or you can have control over the system (active) such that it will never arm itself.
Note: When the system is armed, the vehicle will not start with the key unless the system has
armed (If installed). The system, when armed, will control a relay that will physically interrupt the
vehicle starter wire and prevent the starting of your vehicle. The system is selectable, passive or
active arming; this means that you can have the unit arm itself (passive) after a pre-programmed
period of time, or you can have control over the system (active) such that it will never arm itself.
Note: When the system is armed, the vehicle will not start with the key unless the system has
been disarmed.
To Arm the Starter Disable
•
Lock the doors by remote or wait the time-out period in passive arm mode. The system is armed
automatically when the doors are locked by remote.
automatically when the doors are locked by remote.
To Disarm the Starter Disable
•
Unlock the doors by remote or place the unit into Valet Mode.
Retain Accessory Output
Retain Accessory output is activated as soon as the key is turned to the
ON
position. When the key
goes from
ON
to
OFF
position, the accessory output stays
ON
and a countdown period of 10
minutes is set. The output is turned
OFF
after 10 minutes or if a door is opened anytime during the
countdown period.
Note: The Accessory Output is also turned off while starting the car.
Note: The Accessory Output is also turned off while starting the car.
System L.E.D. Flash Rate
The L.E.D will display the status of the system, to indicate if the starter kill is armed or disarmed.
The L.E.D will also indicate if the system is in Valet Mode or not.
The following are L.E.D conditions:
The L.E.D will also indicate if the system is in Valet Mode or not.
The following are L.E.D conditions:
L.E.D State
System Status
Mode
OFF
Starter kill Disarmed Regular
operation
ON Solid
Starter kill Disarmed
Valet Mode
Flashing slowly
Starter Kill armed
Regular operation
Flashing quickly
System is in rearming sequence
Passive arming Mode