Autodesk XW8400 Benutzerhandbuch

Configuring Lustre to Connect to the Autodesk Control Surface

   

33

After you have configured the IP address of the control surface, you must configure Lustre to 
use the control surface.

Turn the power on to each of the modules and look at the top display panel on the module. 
It should display the panel name and ID.

After you install Lustre 2009, open the init.config file located in C:\Program 
Files\Autodesk\<lustre version>  in Windows, or in /usr/autodesk/<lustre version> in Linux 
with a text editor.

In the ControlSurface section of the init.config file of your project, enter the panel IDs 
for each panel. 

ControlSurface
AutodeskPanels state=”On”
PanelIDs function=”0” grading=”0” navigation=”0”
Once the steps above are completed, the ACS panels will be recognized, loaded, and 
connected when launching the application.

Start Lustre. The following message should appear in the Console:

Panel #<panel_ID> is detected

This confirms that the Autodesk Control Surface is enabled.

If you do not have the modular Autodesk control surface panel that includes the tablet, you can 
connect a stand-alone tablet.

To connect a stand-alone tablet, connect the tablet to USB Out 1 on the USB extender.

On Windows-based workstations, you may need to restart Windows for the tablet to be 

recognized. On Linux-based workstations, re-starting the Xserver prompts tablet recognition. 

Press 

 to start the Xserver.

The Slave Renderer is available for the Master Station, the Lustre Station, and the Lustre HD 
Station, all of which must be running on a Windows-based workstation. The Slave Renderer is