Autodesk HP Workstation xw9400 Benutzerhandbuch

BIOS and Firmwares

   

7

XLR-3 cables shipped with your system. Using any other cables may cause humming in the 
system.

When you receive your shipment, check all the boxes for dents or other markings that may 
indicate damage during transport. If you suspect a component is damaged, carefully inspect it 
before setting up the system. If you receive a damaged component, call Customer Support.

Use the enclosed packing checklist to ensure that you received all of the parts.

In most cases, hardware integration and application installation are done on delivery by an 
authorized technician, so you should not have to verify or upgrade the BIOS or the different 
firmwares. But, if you are upgrading your Effects or Editing application yourself, you must 
follow the next procedures.

System configuration is done prior to delivery by an authorized technician. The procedures in 
this section may not be necessary, and are provided here for informational purposes only. 

The system BIOS on your workstation must correspond to the certified version required by 
your Effects or Editing application version. If the BIOS version on your system does not 
correspond to the table below, you must update to the certified version. 

The BIOS version installed on your system appears on the screen while booting the 
workstation. The following procedure describes how to update a Linux workstation to the 
certified BIOS version required by your Autodesk Effects or Editing application. 

Load the DKU CD in the CD-ROM drive on the workstation.

Open a terminal.

Type:

2008

1.05