Autodesk HP Workstation xw9400 Benutzerhandbuch

Introduction

1

12

   

System configuration is done prior to delivery by an authorized technician. The following 
procedures may not be necessary, and are provided here for informational purposes only.

The firmware on your AJA OEM-2K PCI-X (AJA PCI-X) must correspond to the certified 
version required by your Effects or Editing application version. If the firmware on your AJA 
PCI-X board does not correspond to the table below, you must update it to the certified version. 

The AJA PCI-X firmware update utilities required to check your firmware version are included 
with the DKU version associated with the release of your Effects or Editing application. The 
following procedure describes how to verify the firmware version of the AJA PCI-X.

h

Type:

An output similar to the following should appear:

If there is no aja file in /proc/driver, you are using an outdated driver or the driver is not 

loaded and you must install the latest DKU for your workstation. Refer to the Autodesk Effects 

and Editing 2008 Software Installation Guide for Linux Workstations.

The firmware on your AJA PCI-X must correspond to the certified version required by your 
Effects or Editing application version. If you verified the firmware on your AJA PCI-X and it did 
not match the certified version, you must update it. The following procedure describes how to 
update the firmware of the AJA PCI-X to the certified version required by your Effects or 
Editing application.

2008

0x50

AJA Driver Name: oem2k
Version: 4.1 Beta 9

Card #: 0
Board Version String: OEM 2K - Rev 0
PCI Version: 0x50
Board ID: 10196500
FPGA built on 2006/08/17 at 08:21:11