Autodesk HP Workstation xw9400 Benutzerhandbuch
1
Introduction
Summary
About This Guide
This guide describes how to set up the HP® xw9400 workstation for your Autodesk® Effects or
Editing 2008 application.
Editing 2008 application.
If you already own an HP xw9400 workstation shipped with the 2007 release of your Effects or
Editing application, you do not need to change its configuration. But, you do need to verify its
BIOS and firmware settings. See
Editing application, you do not need to change its configuration. But, you do need to verify its
BIOS and firmware settings. See
Use this guide in conjunction with the Software Installation Guide for Linux Workstations, the
Configuration File Reference Guide for Linux® Workstations, the Stone Direct Configuration
Guide, and the Stone and Wire Filesystem and Networking Guide to install and configure the
hardware and software components of your Effects or Editing products.
Configuration File Reference Guide for Linux® Workstations, the Stone Direct Configuration
Guide, and the Stone and Wire Filesystem and Networking Guide to install and configure the
hardware and software components of your Effects or Editing products.
N
OTE
:
In most cases, both hardware setup and application installation is done on delivery by an
authorized technician, so you may not need to perform some of the procedures in these guides.
The latest versions of all guides are available in PDF format from the Web at
http://www.autodesk.com/discreet-documentation. Use XPDF or Adobe® Acrobat® Reader™ to
view and print the PDF files.
http://www.autodesk.com/discreet-documentation. Use XPDF or Adobe® Acrobat® Reader™ to
view and print the PDF files.