Aruba Networks Access Point Aruba AP 60/61 Benutzerhandbuch

9

Installation Guide

Chapter 2

enabled on the network, the Aruba Mobility Controllers need to be on the same 
broadcast domain as the AP or an “IP Helper” must be configured to direct the 
broadcast ADP packets to the Aruba Mobility Controller. 

Once these discovery prerequisites are met, the Mobility Controller will respond 
to APs with the IP address of the Master Aruba switch. The APs can then obtain 
their image and configuration.

To enable ADP on an Aruba Mobility Controller, enter:

To enable IGMP-Join on an ADP multicast group on an Aruba Mobility Controller, 
enter:

If you have location-specific configurations for your Access Points, you 
will need to apply this configuration information using AP Reprovisioning. 
Refer to the ArubaOS User Guide for details on AP Reprovisioning and 
see the feature description below.

AP Reprovisioning is the process by which APs are assigned, for example, 
location codes. Location codes are important for recalibration and triangulation. 
For details on AP Reprovisioning, see the ArubaOS User Guide.

AP Provisioning is useful for brand new APs with default configurations.  To 
perform AP Provisioning from the WebUI:

Go to 

.

On this window, there are two tabs: 

 and 

. The 

Provisioning tab is selected by default.