Ampro Corporation XTX 820 Benutzerhandbuch

Chapter 4

BIOS Setup Utility

Reference Manual

XTX 820

BIOS Security Setup Screen

Main Advanced Boot Security Power Exit

BIOS Setup Utility

Security Settings

Select Screen

          Select Item
Enter    Change
F1       General Help
F10      Save and Exit
ESC   Exit

Supervisor Password: Not installed
User Password: Not installed

Change Supervisor Password
Change User Password

Boot Sector Virus Protection [Disabled]

Hard Disk Security
Hard Disk Security User Passwords
Hard Disk Security Master Passwords

Install or change
the password

Figure 4-4. BIOS Security Setup Screen

Security Settings

• Supervisor Password – [Installed] or [Not Installed]

Indicates if a supervisor password has been set.

∗ If the password has been installed, Installed appears on screen.
∗ If no the password has be selected, then Not Installed appears on screen.

• User Password – [Installed] or [Not Installed]

Indicates if a user password has been set. If the password has been installed, Installed displays.
If not, Not Installed displays.

• Change Supervisor Password

a. Select Change Supervisor Password from the Security Setup menu.

b. Press <Enter> to access the pop-up menu, Enter New Password:

c. Type the password and press <Enter> again.

The screen will not display the password as you type.

d. Retype the password when prompted by the pop-up menu and press <Enter> again.

If the password is not confirmed when you retype it, an error message will appear. The
password is stored in NVRAM and you have successfully entered the password.

To clear Supervisor password: .

a. Press <Enter> to access the pop-up menu, Enter New Password:

b. Do not enter a password and press the <Enter> key, following the prompts.

c. Repeat this process until the old password is gone, which is indicated by Not Installed.