AMANO HandPunch 1000 Installationsanweisungen

HandPunch 1000 Installation and Operation Manual

Revision 1.2

Page 39

Set Language
The Set Language command allows the language shown on the HandPunch’s display 
to be “localized” for a variety of countries.

-

English

-

German

-

Japanese

-

Russian

-

French

-

Indonesian

-

Italian

-

Portuguese

-

Spanish

-

Polish

Set Date Format
The Set Date Format command allows the date format shown on the HandPunch’s 
display to be “localized” for a variety of countries.

-

mm/dd/yy

-

mm-dd-yy

-

dd-MMM-yy

-

MMM dd,yy

-

dd-mm-yy

-

ddMMMyyyy

-

dd/mm/yy

Set Time and Date
The Set Time and Date command allows the HandPunch’s time and date to be set. This 
is normally not necessary as the HandPunch’s time and date are set by the host 
computer.

Set Address
The Set Address command allows a unique address to be set for each HandPunch. For 
proper operation, each HandPunch in the network must have a unique address. All 
units may use any address from 0 to 254. The factory default is for all units to be sent 
with the address set to 1.

Set ID Length
The Set ID Length command allows you to reduce the number of keystrokes required 

to enter the ID number by eliminating the use of the 

 key to complete an ID 

number entry. Once the ID Length is set, the HandPunch will automatically accept an 
ID number entry once the correct number of characters have been entered.

Set ID Length does not apply when ID entry is made from a card reader. Once the ID 
Length is set, the T & A Mode Set command appears, allowing you to configure the 
HandPunch to prepare punch data for time and attendance software.