Amana Ice Maker IA 52204-0001 Benutzerhandbuch

15

6.

Place charcoal briquettes randomly throughout
newspaper.

7.

Close doors and let stand 24–48 hours.

8.

Remove charcoal briquettes and newspapers.

9.

Complete steps 2–3.

Contact Consumer Affairs Department if odor was still not
eliminated.

1.

Remove glue residue by rubbing toothpaste into
adhesive with fingers until adhesive loosens.

2.

Rinse surface with warm water. Dry surface with a
soft, clean cloth.

1.

Clean door gaskets as necessary according to
General instructions. Gaskets must be kept clean
and pliable to assure proper seal.

2.

Apply a light film of petroleum jelly on hinge side of
gasket to keep gaskets pliable.

Clean condenser coil every 3 months to ensure maximum
performance of refrigerator. Accumulated dust and lint
may cause the following:

• reduced cooling performance
• increased energy usage
• premature part failure

1.

Remove toe grille by holding ends and pulling
forward.

2.

Clean front surface of condenser coil with a vacuum
cleaner hose nozzle.

3.

Replace toe grille by inserting clips in holes and
snapping in.

To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.

Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following steps:
1.

Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let set for 5 minutes.

2.

Spray warm water into crevices using faucet spray
attachment.

3.

Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering front.

To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After replacing
light bulb, connect power.

To avoid personal injury or property damage, observe
the following:

• Allow light bulb to cool.
• Wear gloves when replacing light bulb.

•

Remove light bulb cover by removing ¼" hex nut
screws.  Replace with appliance bulb no greater
than 60 watts.

•

Replace light bulb cover by replacing ¼" hex nut
screws.

A ¼" hex nut screws

B

Light bulb cover

This refrigerator is designed to be one of the most energy
efficient refrigerators available. Reduce energy use by
observing the following.

• Operate in normal household temperatures of 55° to

110°F (13°C to 43°C) away from heat sources and
direct sunlight.

• Set Fresh Food, Deepfreeze

®

, and drawer controls

no colder than necessary.

• Keep Deepfreeze

®

 section full.

• Keep door gaskets clean and pliable. Replace

gaskets if worn.

• Keep condenser coils clean.

Complete the following steps for short vacations.
1.

Remove perishable foods. Warranty does not cover
food loss. Check warranty certificate for specific
coverage.

2.

If an ice maker is installed, move ice maker arm to
off position.

Complete the following steps for long vacations.
1.

Empty Fresh Food and Deepfreeze

®

 sections.

2.

Unplug refrigerator.

3.

Clean refrigerator and door gaskets according to
General instructions in Care and Cleaning section.

4.

Prop doors open, so air can circulate inside.

5.

If an ice maker is installed, turn water supply to
refrigerator off and move ice maker arm to off
position.