Alvarion BreezeMAX Wi and BreezeACCESS Wi 214486 Benutzerhandbuch
22
Installation
Chapter 2 - Hardware Installation
3
Adjust the tilt angle according to the scale marked on the mounting plate and
tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
2.3.3
Connecting the Wi² Unit to the SU-ODU
2.3.3.1
Connecting to BreezeMAX PRO-S ODU
1
The rubber sealing cap (supplied with the SU-ODU) has a special groove
allowing to insert an ethernet cable with an already assembled RJ-45
connector through the cap. To expose the groove, lightly squeeze the cap (see
allowing to insert an ethernet cable with an already assembled RJ-45
connector through the cap. To expose the groove, lightly squeeze the cap (see
Figure 2-8
). Carefully insert the end of the 55 cm category 5E Ethernet cable
without the service box through the groove.
Figure 2-7: Attaching the Mounting Plate to the Wi² Unit
NOTE
The Wi² installation kit includes a Category 5E Ethernet cable, suitable for connecting to
BreezeMAX PRO-S ODU. For instructions on how to adapt the Ethernet cable for connecting to a
BreezeACCESS SU-ODU with HW revision D or lower refer to
BreezeMAX PRO-S ODU. For instructions on how to adapt the Ethernet cable for connecting to a
BreezeACCESS SU-ODU with HW revision D or lower refer to