Alfa Romeo 147 Benutzeranleitung

Seite von 286
GETTING TO KNOW YOUR CAR
19
BACK REST TILTING 
(fig. 15)
To gain access to the rear seats, pull the
handle (
E), the back rest folds and the seat
is free to run forwards.
A recovery mechanism with memory
makes it possible to take the seat back to
its previous position.
Once the seat back has been returned to
the travelling condition, make sure that it
is correctly clamped, checking that the “red
band” on the upper part of the handle (
E)
is concealed. In fact, this “red band” indi-
cates that the seat back is not clamped.
Also check that the seat is firmly locked on
the runners, trying to move it to and fro.
DRIVER’S SEAT LUMBAR
ADJUSTMENT
(fig. 15)
Adjustment is done by turning the knob
(
D) until reaching the most comfortable po-
sition.
CENTRAL ARMREST 
(fig. 16)
(upon request for versions/markets
where applicable
)
The armrest can be adjusted, raised and
lowered.
To adjust, slightly raise the armrest, then
press the the release device (
A).
Inside the armrest there is an oddments
compartment, to use it, raise the cover,
pressing the device (
B).
fig. 16
A0A0023m
ADJUSTING THE HEIGHT 
(fig. 15) (upon request for
versions/markets where
applicable
)
To raise the seat, pull the lever (
B) up-
wards, then work the lever (up and down)
until reaching the required height, then re-
lease it. To lower the seat, push the lever
(
B) downwards, then work the lever (up
and down) until reaching the required
height.
IMPORTANT Adjustment must be car-
ried out only seated in the driver’s seat.
BACK REST ANGLE
ADJUSTMENT
(fig. 15)
This can be done by turning the knob (
C)
until the desired position is reached.
001-057 Alfa 147 Q2 GB  4-07-2008  11:58  Pagina 19