Alfa Romeo 147 Benutzeranleitung
VEHICLE MAINTENANCE
244
NOTE Clean accurately the tank cap A
and the surrounding surface. When opening
the cap take the utmost care to prevent im-
purities entering the tank. When topping up,
always use a funnel with built-in filter with
mesh equal to or lower than 0.12 mm.
the cap take the utmost care to prevent im-
purities entering the tank. When topping up,
always use a funnel with built-in filter with
mesh equal to or lower than 0.12 mm.
IMPORTANT For this operation it is
however recommended to contact Alfa
Romeo Authorised Services.
Romeo Authorised Services.
fig. 12
A0A0217m
fig. 11 - JTD
M
versions
A0A0400m
Make sure that the high-
ly corrosive brake fluid
does not drip onto the
does not drip onto the
paintwork. If it does, wash it off
immediately with water.
immediately with water.
If the oil level in the reservoir is below the
specified one, top up only with one of the
products listed in the “Fluids and Lubricants”
table in the “Technical Specifications” chap-
ter proceeding as follows:
products listed in the “Fluids and Lubricants”
table in the “Technical Specifications” chap-
ter proceeding as follows:
– Start the engine and wait for the oil lev-
el in the reservoir to stabilise.
– With the engine running, turn the steer-
ing wheel lock to lock a few times.
– Top up to the
MAX level notch, then
refit the cap.
Oil consumption is very
low, if topping up again is
needed shortly afterwards,
needed shortly afterwards,
have the system checked for pos-
sible leaks by Alfa Romeo Autho-
rised Services.
sible leaks by Alfa Romeo Autho-
rised Services.
Do not allow the power
steering fluid to touch hot
steering fluid to touch hot
parts of the engine: it is inflam-
mable.
mable.
WARNING
BRAKE AND HYDRAULIC
CLUTCH FLUID (fig. 12)
CLUTCH FLUID (fig. 12)
Check that the fluid level in the reservoir
is at maximum. Top up with the brake flu-
id specified in the table “Fluids and lubri-
cants” (see section “Technical Specifica-
tions").
id specified in the table “Fluids and lubri-
cants” (see section “Technical Specifica-
tions").
234-257_Alfa147 Q2 GB 4-07-2008 12:05 Pagina 244