ADIC SNC 5100 Benutzerhandbuch

This section covers installation of the SNC 5100, SCSI devices, and Host Bus 
Adapter.

Before you or your service representative installs the SNC 5100, you must 
perform the steps in the "Pre-installation Procedure".

It is important that the steps in this procedure are completed before you begin 
the installation of the SNC 5100. This ensures a successful installation of the 
product.

1

Verify that the required host platform 
operating system version is 
compatible with the installed Fibre 
Channel Host Bus Adapter (HBA).

 2

Verify that the HBA BIOS and device 
drivers have been procured and are 
installed in host system(s).

For the most current list of supported 
HBAs, the required BIOS and device 
driver, visit www.adic.com.
See “Host Bus Adapter Setup” on 
page 29.

 3

Optionally, install the Host 
Registration Service on the hosts that 
will be connected to the SNC 5100. 

Consult your service representative.

For more information on Access 
Options, see the ADIC Management 
Console User Guide.

 4

Ensure that all host Fibre Channel 
cables
° Have been ordered with the product 
or 
° Have been preinstalled and checked 
and
° Are labeled with host system 
identifier.

Refer to the HBA Specification provided 
with your HBA.