A&D MF-50 Benutzerhandbuch

MS-70 / MX-50 / MF-50 / ML-50

13.3.

13.3. Calibration of Drying Temperature

Calibration of Drying Temperature

Calibration of Drying Temperature (for MS

(for MS

(for MS----70 and MX

70 and MX

70 and MX----50)

50)

The temperature calibrator (accessory AX-MX-43)

adjusts the drying temperature on the pan. Put the
sensor on the pan and input measurement data at
100°C and 160°C.

Each adjustment needs fifteen minutes. The buzzer

sounds at the end.

t-Up

is displayed after no adjustment for five

minutes during the operation and calibration is
stopped. Press any key to return to weighing mode.

Refer to the instruction manual of the certified

temperature calibrator (accessory AX-MX-43).

13.3.1.

13.3.1. Operation

Operation

1. Replace the weighing pan with the sensor pan

of the temperature calibrator.

2. Curve the sensor wire so it does not touch the

heater cover and glass-housing when closing
heater cover.

Level the sensor pan.

Do not leave a gap between the pan support

and the sensor.

3. Turn on the analyzer.

Display the gram unit (of the weighing mode)

4. Press and hold the

PROGRAM

key

5. Press

the

SELECT

key to display

t-Cal

6. Press

the

ENTER

key.

7. Press

the

START

key to start the 100°C

measurement.

8. After fifteen minutes, the buzzer sounds and blinks

"1"0"0°C

. Adjust the blinking value to the

thermometer value using the

↓

↑

key. (Example:

97°C)

9. Press

the

ENTER

key to store the new data and

to start the 160°C measurement.

15 min.

0.000

t-Cal

15 min.

Buzzer

100℃ "1"0"0℃

100℃ "9"7℃

Leave no gap

Level the sensor pan.
Curve the sensor wire so as not to touch heater cover.

Leave no gap

Sensor pan

Thermometer

Sensor pan