Directed Electronics OHDW17.2 Benutzerhandbuch

© 2005 Directed Electronics—all rights reserved

Press "MENU" 

button on the monitor or remote to activate the screen parameters set-up. The

sequence of set-up items is as follows:

FM: Transmitting frequency

SHARPNESS: Sharpness adjustment

BRIGHTNESS: Brightness adjustment

CONTRAST: Contrast adjustment

SATURATION: Color saturation adj.

HUE: Color hue adjustment

RESET: Resets above (except FM) to factory default settings.

Once the desired setting is selected, press the cursor buttons to adjust the setting. On the remote

use the up/down cursor buttons located at either side of the menu button. On the monitor use the

cursor buttons to the right side of the 

button. If a button is not activated within 5 seconds,

this function mode will turn OFF. Once the correct function is selected, press the cursor button (to

set the desired setting). If no button is pressed, the menu mode will turn OFF in about 5 seconds.

The FM frequency setting allows the monitor to transmit audio to the vehicle’s radio. Use a frequency

that is not interfered with from a local broadcast station. This setting also has an OFF position.

Engage this switch 

on the monitor to activate the dome lights when a door is open.

Activate this switch 

on the monitor to control the dome light illumination.

FM

    →  

 

SHARPNESS 

→

    BRIGHTNESS  →    CONTRAST → 

    SATURATION 

→

    HUE  →    RESET