Delta Tau TURBO CLIPPER DRIVE Benutzerhandbuch
Turbo Clipper Drive User Manual
Motor Setup Guidelines
55
MOTOR SETUP GUIDELINES
This section provides with manual (step by step) motor setup guidelines for stepper, DC
brushless, and brush motors. This motor setup segment should be the last of a few necessary
steps to properly configure a motor with Turbo Clipper Drive drives.
brushless, and brush motors. This motor setup segment should be the last of a few necessary
steps to properly configure a motor with Turbo Clipper Drive drives.
Motor Setup Flow Chart
Note
For encoder-driven motors (none steppers), this section assumes
that feedback device(s) have been setup properly, and that
moving the motor/encoder shaft by hand shows correct data in
the position window.
that feedback device(s) have been setup properly, and that
moving the motor/encoder shaft by hand shows correct data in
the position window.
Encoder/Motor Wiring
Motor Type & Protection PLC
(Add, remove axes as necessary)
Encoder Software Setup. Verify Feedback, Rotate Shaft By Hand.
(Not applicable for steppers)
Factory default Reset $$$***, Save, $$$
(Recommended for fresh installation)
Motor Setup By Type For Each Channel
Dominant Clock Settings
(Once per unit setup)