Delta Tau TURBO CLIPPER DRIVE Benutzerhandbuch
Turbo Clipper Drive User Manual
Appendix B
85
E13: Power-Up/Reset Load Firmware
E Point
Description
Default
E13
Jump pin 1 to 2 to reload Turbo PMAC2 firmware.
Remove jumper for normal operation.
Not
Installed
E14- E17: Ports Direction Control
E Point
Description
Default
E14
Install jumper to make DATx lines inputs.
Remove jumper to make DATx lines outputs.
Jumpered
E15
Install jumper to make SELx lines inputs.
Remove jumper to make SELx lines outputs.
Not
Installed
E16
Install jumper to make MOx lines inputs.
Remove jumper to make MOx lines outputs.
Not
Installed
E17
Install jumper to make MIx lines inputs.
Remove jumper to make MIx lines outputs.
Jumpered