DCS 36-48" BGB Grill BGB36-BQAR Benutzerhandbuch
18
TO LIGHT DUAL SIDE BURNERS (48BQR MODELS ONLY):
CAUTION:
The side burner cover may be hot if the grill burners are in operation.
Side Burners Lighting Instructions:
First remove the burner cover and any cooking utensils
from the burner grate.
from the burner grate.
Push and hold the ignition
button, turn the control knob to the “HI” position until
the burner is lit or 4 seconds pass. If the burner doesn’t
ignite, wait 5 minutes for any accumulated gas to
dissipate then try again. If the burner will not light after
several attempts.
the burner is lit or 4 seconds pass. If the burner doesn’t
ignite, wait 5 minutes for any accumulated gas to
dissipate then try again. If the burner will not light after
several attempts.
Check the troubleshooting
instructions on page 27. To light burner manually see
page 17,“Match Lighting”.
page 17,“Match Lighting”.
Side Burners Match Lighting:
Hold a fireplace lit match near the burner ports, turn the
control knob counterclockwise to “HI”. Move your hand
immediately once the burner is lit. Rotate the control
knob to the desired setting.
control knob counterclockwise to “HI”. Move your hand
immediately once the burner is lit. Rotate the control
knob to the desired setting.
Note: If you are using propane gas, a slight pop or flash may occur at the burner ports
a few seconds after the burner has been turned “off”. This “extinction pop” is
normal for propane gas.
normal for propane gas.
Side burners:
Your new side burner is equipped with burners typical
of those used in restaurants (Fig.19). These burners are
designed for maximum cleanability and controlability.
The burner should never be operated if the cap is not in
place.
of those used in restaurants (Fig.19). These burners are
designed for maximum cleanability and controlability.
The burner should never be operated if the cap is not in
place.
LIGHTING INSTRUCTIONS
FIG.18
IGNITION
FIG.19
Cap
Ignition
Control Knobs