Datacard Group RL90 Benutzerhandbuch

Using the LCD menus

RP90 Plus E and RL90 User Guide

37

Ink

Ink Type

YMCK: 0
YMCKPO: 2
YMCKK: 4

Displays the type of ink ribbon that is loaded in the printer. 
Datacard supports YMCK and YMCKK ink ribbons. (The printer 
detects the type of ink ribbon; it cannot be set.) See your dealer 
regarding support for YMCKPO ink ribbon.

Black level

Choose from seven gradations from -3 (lighter) to +5 (darker).

Black mode

Choose Standard or Fine. Change to Fine if thin lines or small 
black text is blurred (printing speed is slower).

SP - Ink1 Level

Use SP - Ink1 and Ink2 levels to set the darkness level of 
special inks that will be available in the future.

SP - Ink2 Level 

See SP -Ink1 Level above.

Retransfer

Media type:

750
1000

Datacard retransfer ribbon is available in 1000 frames per roll.

Temp Level

Set the retransfer roller temperature. Set from -3 (lower) to +2 
(higher).

Speed (front)

Set the retransfer speed for the front of the card. Set from -10 
(slower) to +2 (faster). Initialize the retransfer film after making 
changes. See 

.

Speed (back)

Set the retransfer speed for the back of the card. Set from -10 
(slower) to +2 (faster). Initialize the retransfer film after making 
changes. See 

.

MG Print (JIS)

Select ON or OFF.

Standby

Front Wait
Back Wait

When printing both sides of a card and using an optional 
smart card (IC) unit, specifies whether to wait after the front 
side or the back side of the card. 

Buzzer

ON or OFF

Use to turn the electronic beep sound ON or OFF. The sound 
can indicate an error, when fewer than 20 cards remain in the 
card hopper, or to confirm a menu selection.

Power Saving

OFF or up to 60 minutes

The printer enters power save mode after a specified period 
of inactivity. Choose from OFF or select from 5 to 60 minutes 
in 5 to15 minute increments. “Sleeping” appears on the LCD 
display. To cancel power save mode, press RESET and then 
the ENTER key. The printer uses one set of supplies.

Bend Remedy

Temp Level

Choose from -5 (lower) to 0 (higher) or OFF to set the bend 
remedy roller temperature. See 

 

for more information.

Speed

Choose from -2 (slower) to +2 (faster) to set the bend remedy 
speed. See 

 for more 

information.

Cooling time

Set the cooling time from 0 (None) to 15 seconds.