Garmin Vector S Benutzeranleitung

NOTE: The right pedal has a left-handed (reverse) thread.

Remove the pedal body. 

While securely holding the spindle 

Á

 with a pedal wrench, 

use the 8 mm hex nut driver to remove the nut 

Â

 and washer 

Ã

.

Separate the cartridge from the spindle.

Remove the brass spacer ring 

Ä

 and dust seal 

Å

.

NOTE: The Vector S right pedal does not include the brass 

spacer, and the dust seal is reversed.

Remove all old grease from the spindle.

Slide the new dust seal and brass spacer ring over the 

spindle.
The tapered side of the dust seal and brass spacer ring must 

face the base of the spindle.

Apply a layer of bike grease to the spindle.

Insert the spindle into the cartridge.

Wipe away all excess grease.

Install the new washer and nut on the end of the spindle.
NOTE: The nut for the right spindle has a left-handed 

(reverse) thread.

Use the 8 mm hex nut driver to tighten the nut.

Garmin recommends torque of 7 lbf-ft. (10 N-m). Failure to 

properly tighten the nut could cause the pedal to fall off 

during a ride, which could result in property damage or 

serious bodily injury or death.

Install the new pedal by screwing it onto the cartridge until 

there is no gap.
NOTE: The right pedal has a left-handed (reverse) thread.

Replace the pedal pods and pedals according to the 

installation instructions (

).

Rotate the crank arm to check for clearance and smooth 

pedal rotation.

After you replace the pedals and cartridges, you must 

recalibrate the system.

If you are transporting your bicycle or not using Vector for an 

extended period of time, Garmin recommends removing Vector 

and storing it in the product box.

Battery type

User-replaceable CR2032, 3 volts

Battery life

Minimum 175 hours of riding time
NOTE: The pedal pod used on the right crank will 
drain the battery faster than the left crank.

Operating 
temperature range

From -4° to 122°F (from -20° to 50°C)

Water resistance

IPX7

Do not submerge or pressure wash the 
components.

Radio frequency/
protocol

2.4 GHz ANT+ wireless communications protocol

Power source

USB

Operating temperature 
range

From 14° to 122°F (from -10° to 50°C)

Radio frequency/protocol

2.4 GHz ANT+ wireless communications 
protocol

Transmission range

Approximately 16.4 ft. (5 m)

Vector monitors the battery level of both pedal pods and sends 

status information to your Edge device. When you receive a low 

battery warning, you have approximately 10–20 hours of 

operation time remaining.

Do not use a sharp object to remove user-replaceable batteries.
Contact your local waste disposal department to properly 

recycle the batteries. Perchlorate Material – special handling 

.

NOTE: Always replace both batteries at the same time.

Locate the circular battery cover 

À

 on the back of the pedal 

pod.

Use a coin 

Á

 to twist the cover counter-clockwise, moving 

the arrow from locked 

Â

 to unlocked 

Ã

.

Remove the cover.
You can use a piece of tape 

Ä

 or a magnet to remove the 

battery from the cover.

Wait 30 seconds.

Insert the new battery into the cover, observing polarity.
NOTE: Do not damage or lose the O-ring gasket.

Replace the cover, making sure the arrow points to unlocked.

Device Information

5