BMW 2007 X5 4.8i SAV Benutzeranleitung
57
Do not allow the engine to warm up by leaving it
running while the vehicle remains stationary.
Instead, drive off at a moderate engine speed.
running while the vehicle remains stationary.
Instead, drive off at a moderate engine speed.
The engine starts when you depress the
brake pedal while briefly pressing the
brake pedal while briefly pressing the
Start/Stop button.
<
Procedure
1.
Depress brake pedal.
2.
Briefly press the Start/Stop button.
The system responds by automatically engag-
ing the starter for a certain period and automat-
ically disengaging it as soon as the engine
starts.
ing the starter for a certain period and automat-
ically disengaging it as soon as the engine
starts.
Special starting conditions
Depress the accelerator pedal half way when
starting the engine in the following situations:
starting the engine in the following situations:
>
The engine fails to start on the first attempt,
e.g. if it is very hot or cold.
e.g. if it is very hot or cold.
>
The engine is started at very low tempera-
tures, below approx. +5
tures, below approx. +5
7/–156, at high
altitudes, over approx. 3,300 ft/1,000 m.
Avoid frequent starting in quick succes-
sion or repeated starting attempts in
sion or repeated starting attempts in
which the engine does not start. Otherwise, the
fuel is not burned or inadequately burned and
there is a danger of overheating and damaging
the catalytic converter.
fuel is not burned or inadequately burned and
there is a danger of overheating and damaging
the catalytic converter.
<
Switching off engine
When leaving the vehicle, always take the
remote control with you.
remote control with you.
When parking on a downhill incline, set the
parking brake, otherwise the vehicle could roll
away.
parking brake, otherwise the vehicle could roll
away.
<
Procedure
1.
Engage transmission position P with the
vehicle stopped.
vehicle stopped.
2.
Briefly press the Start/Stop button.
Procedure before driving into a car
wash
The vehicle can roll if you proceed according to
the following steps:
the following steps:
1.
With comfort access
*
: insert the remote
control into the ignition lock.
2.
Depress brake pedal.
3.
With the engine running, engage transmis-
sion position N.
sion position N.
4.
Release the parking brake.
5.
Switch off the engine.
6.
Leave the remote control in the ignition
lock.
lock.
Transmission position P will be engaged:
>
automatically after approx. 30 minutes
>
if you remove the remote control from the
ignition lock
ignition lock
Parking brake
The concept
Your BMW is equipped with an electromechan-
ical parking brake that is set and released with a
button.
The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked.
With the engine stopped, the parking brake acts
on the rear wheels via an electromechanical
system. When the engine is running, the park-
ing brake acts on the disc brakes of the front
and rear wheels via the brake hydraulics.
ical parking brake that is set and released with a
button.
The parking brake is primarily intended to pre-
vent the vehicle from rolling while parked.
With the engine stopped, the parking brake acts
on the rear wheels via an electromechanical
system. When the engine is running, the park-
ing brake acts on the disc brakes of the front
and rear wheels via the brake hydraulics.
Online Edition for Part no. 01 41 0 012 501 - © 08/06 BMW AG