Baby Trend 2.1 Benutzerhandbuch

ASSEMBLY

IMPORTANT!

To ensure safe operation of your stroller,

please follow these instructions carefully. Please keep these

instructions for future reference.

IMPORTANT!

Before assembly and each use, inspect this

product for damaged hardware, loose joints, missing parts or sharp

edges. NEVER use if any parts are mssing or broken.

IMPORTANT!

Adult assembly is required.

ASSEMBLY

Remove stroller from box. The front wheels,

rear wheels, child tray, and parent tray

MUST

installed prior to use.

FRONT WHEELS

To attach the front wheels, unfold stroller as

described in the section following:

• Unlock the red release lever.
• Unfold stroller frame by pulling backward

on the stroller handle (Fig. 1)

To attach the front wheels, lean the stroller back

so that it rests on the handle with the front and

rear legs pointing upward. Position the front

wheels over the front leg tubes so that the hole in

the housing lines up and will slide onto the legs.

(Fig. 2) Firmly push down until the wheels lock

securely into place. Tug on each wheel to ensure

they are both securely attached.

REAR WHEELS

Position rear axle over the rear leg tubes, brake

pedals facing the back. At the same time, push

down applying equal pressure to both sides until

they lock into place. (Fig. 3)
Note:

NEVER

use stroller if wheels do not lock into

place.

If you need assistance, please contact our

customer service department at 1-800-328-7363,

M-F, between 8am and 4:30pm, PST.

FOOT REST

Push downward on the foot rest until it snaps onto

the U-shaped frame cross member. (Fig. 4)

PARENT TRAY

To attach the parent tray, position the tray so that

the hinges for the storage compartment are facing

foward. Snap the parent tray to the stand at the

top of the frame. Check that the tray is securely

latched in place. (Fig. 5)

CHILD TRAY

To attach the child tray:

Push the tray downward and onto each side of the

front armrests until both side snaps into place.

(Fig. 6) Check that tray is securely latched in

place. Repeat the above step for the rear child tray.

WARNING:

The child’s tray

is not a restraint device: always secure

your child with the seat belt. DO NOT

lift the stroller by the child’s tray. Use

care when attaching the child’s tray on

the stroller with a child in the stroller.

To access the child seat:

Pull one side of the release lever (Fig. 7) located

on the underside of the child tray and lift upward.

Either side of the child tray will lift and rotate out

of the way to allow access to the front and rear

seats. (Fig. 8)

To rotate the child tray:

In order to attach an infant car seat to the stroller,

Fig. 3

Fig. 2

red release

lever

Fig. 1

Fig. 4

Fig. 5

Fig. 6

release lever

Fig. 8

Fig. 7

Snap On

Push Down