B&B Electronics MES1B Benutzerhandbuch
Configuring the MES1A/B
Manual Documentation Number: MES1A/MES1B-2106m PN7138-rev001
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
28
MES1B for RS-485 two-wire operation, the CP1 parameter must be set for
RS485 Enable to ensure Send Data Control is implemented.
RS485 Enable to ensure Send Data Control is implemented.
No configuration is required in this section for MES1A converters.
To configure RS485 Enable in the Modem/Configurable Pin Settings
section:
section:
33. Type 3 at the
Select Command or parameter set (1..4)
to change:
prompt. The
CP1 Function
prompt appears.
34. Type 4 to select RS485 Enable
35. To accept the change, press Enter
36. Press Enter three more times to exit the Modem/Configurable Pin
Settings section of the Configuration Menu.
4) Advanced Modbus Protocol Settings
In the Advanced Modbus Protocol Settings section of the Configuration
Menu you can configure:
Menu you can configure:
• whether the Slave Address is fixed or used as received
• whether to Allow Modbus Broadcasts
• whether to Use MB/TCP 00BH/00AH Exception Responses
• whether to Disable Modbus/TCP Pipeline
• Character Timeout values
• Message Timeout values
• Serial TX delay after RX values
• whether to Swap 4x/0H to get 3x/1x register conversions
• whether to Allow Modbus Broadcasts
• whether to Use MB/TCP 00BH/00AH Exception Responses
• whether to Disable Modbus/TCP Pipeline
• Character Timeout values
• Message Timeout values
• Serial TX delay after RX values
• whether to Swap 4x/0H to get 3x/1x register conversions
Figure 18.
Advanced Modbus Protocol Settings Menu